Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Cambridge, MA

Roll-Up Door Repair in Cambridge, MA

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Garage doors rarely fail at a convenient time. If you need roll-up door repair in Cambridge, MA, we can often come out the same day when a technician is available. Sheet roll-up doors for storage units, sheds and warehouses repaired.

When to call for roll-up door repair

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

Why this happens

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

What you can check yourself

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

How much does roll-up door repair cost?

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Cambridge, MA and nearby towns

With large seasonal temperature swings in Massachusetts, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our roll-up door repair service covers Cambridge (ZIP codes 02138, 02139, 02140, 02141, 02142 and more) and nearby towns including West Cambridge/Harvard Square (0.7 mi), Somerville (0.9 mi), Kendall Square (1.2 mi) and Lower Allston (1.3 mi). Call (833) 435-8883 to book a visit in Cambridge.

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in Cambridge, MA?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Massachusetts or Cambridge requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Cambridge, MA

Rytec High-Speed Door Repair

Rytec specializes in high-speed doors for warehouses, manufacturing and cold storage.

Typical $400-$2,000

Overhead Door Garage Door Panel Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $300-$900

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Marantec Garage Door Opener Repair

Marantec is a German manufacturer of residential and commercial door openers.

Typical $125-$350

Windsor Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Raynor Garage Door Track Repair

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$400

Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

CHI Overhead Doors Torsion Spring Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $200-$450

Commercial Overhead Door Installation

Commercial sectional, insulated and high-cycle doors and operators installed.

Typical $2,500-$12,000

Overhead Door Opener Gear & Sprocket Replacement

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $125-$275

Northwest Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Cambridge, MA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote